Humble beginnings of the Cady Speedster...
The bike was given to me as a challenge
project to see if there was anything I
could do with her to save her...
The bike was given to me as a challenge
project to see if there was anything I
could do with her to save her...
There were no forks on the frame and she
had been accidented on a farm and run over
by equipment...
...as this allowed carte blanche I decided it
might be a good plan to try to fit a AV7 to
the tiny frame.
Spy pictures of the lower counter spring
rather than a solid mount so there would
always be tension on the belt with the Dimoby...
...and perhaps allow later fitting of a variator...
the tiny frame.
Spy pictures of the lower counter spring
rather than a solid mount so there would
always be tension on the belt with the Dimoby...
...and perhaps allow later fitting of a variator...
Upper mount I fabricated temporary plates
to adapt the upper motor mounting point of
the AV7 to the frame without major
the AV7 to the frame without major
modifications... in case the project needed
more R&D (or perhaps the motor was too much)
It turned out to be very BLASTY fun...
Front forks are from a 50V which fit with
no modification at all.
No comments:
Post a Comment